•
Removing Emulsion Floor Dressing
• Applying Emulsion Floor Dressing
• Maintenance
• Inspection
Removing
Emulsion Floor Dressing
NORSAN RECOMMENDED PRODUCTS: POWER STRIP, RAPID, BLAST OFF
74.
CDX PLUS & BLASTOFF for Linoleum & Rubber.
Apply your chosen polish remover to the floor surface allowing
it to remain on for 5 – 10 minutes or
until the polish has softened. Then scrub the floor thoroughly
using a stripping pad. Wet in, with polish remover from the
tank of the machines as you scrub. When the emulsion polish
has been completely removed, pick up slurry with a wet vacuum
or mopping equipment. Finally, rinse the floor with clean
water before applying the selected floor dressing.
Norsan recommends rinsing the floor surface to make sure all
the slurry has been removed before applying the emulsion dressing.
When using automatic scrubbing machines, double scrub leaving
the vacuum off on the first pass, then vacuum up the slurry
on the second pass.
Applying
Emulsion Floor Dressing
NORSAN RECOMMENDED PRODUCTS: HARD & FAST – Gloss
or Satin, ARMOUR GLOSS – Gloss or Satin.
Make sure the floor is thoroughly clean before applying the
Emulsion Floor Dressing.
Apply with a flat mop or applicator evenly to the floor surface.
Allow 20 minutes or more, drying time before applying a second
coat. A further coat may be needed on heavy traffic areas.
next>> |
